Professional production】 Shandong non-card peeling machine manufacturers, the no card peeling machine price - Zhenguo mechanical 1. Peeling machine [1] the distance between the two chuck decided peeling wood segment length, and thus decided to spin with the width of veneer. It has a maximum distance and a minimum distance. The wood segment length should not be greater than its maximum distance, it is not less than the minimum distance. 2. The center line of the shaft is determined from the height H of the machine bed surface peeling wood segment of the maximum diameter D, and D =, 2H a 100 mm. The maximum diameter of the peeling wood segment also depends on the maximum distance between the center line of the shaft with the knife bed. 3. Rotary knife length 50 mm larger than the maximum distance between the two chuck. 4. The card shaft speed and peeling machine gear transmission, press to ensure the best peeling conditions. Current peeling machine peeling process card shaft speed can be divided into two types, one is the the card shaft speed fixed; another the card shaft speed spin a small increase in the segment with the wood. 5. Work feed speed card axis per revolution or the knife bed (rotary knife and pressure feet) per minute distance moved and mm / rev or mm / meter. Feed rates decided to spin out the thickness of the veneer. In order to get the different thickness of the veneer peeling machine has feedrate transform institutions a feed tank. 6. Fast forward and backward speed of the knife bed knife bed before the start of the peeling knife bed near the wood segment and peeling after leaving the wood the paragraph (wood core), mobile speed. Generally very high speed in order to occupy these actions assisted time to a minimum, the the knife bed quickly retreat. 7. Coarse rotary feed speed is the moving speed of the knife bed before peeling early wood segment spin round. In order to minimize the wood segment spin round time, crude precession knife speed is much higher than the a fine spin feed speed. 8. Shaft axial feed rate should be between the knife bed retraction and wood core release time equal. Shaft axial movement of the screw drive and hydraulic cylinders in two ways. 9. Decision peeled wood core of the diameter of the head card may reach the smallest diameter. 10. The main drive power and peeling machine motor power (in kW), the decision the possible peeling the veneer thickness, as well as the power consumption of veneer peeling. 11. Peeling machine outside dimensions of length, width, and measurement of high protruding part of the machine. The length and width of the plant area decided to install the machine.